F 150 4WD Pickup V8-281 4.6L VIN W EFI (1997)
5.
Remove the slip yoke from the driveshaft and install a revised slip yoke. Refer to the Workshop Manual, Page 205-01-09 for Expedition and
205-01-17 for F-Series, for the proper procedure. Refer to the Slip Yoke Usage Chart to determine the correct part.
6.
Spread 7-13 grams (0.25-0.46 oz.) of Teflon Grease (D2AZ-19590-A) evenly over the slip yoke splines.
7.
Reindex and reinstall the driveshaft by inserting the slip yoke into the extension housing and tightening the axle flange bolts to 88-119 N.m (65-88
lb-ft). Be sure to align the marks on the driveshaft that were previously installed in Step 2.
8.
Drain and refill the transfer case using Motorcraft MERCON(R) Multi-Purpose Automatic Transmission Fluid (ATF) (XT-2-QDX) per the
Service Manual specifications.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 97-12-12
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION
DESCRIPTION
TIME
971321A
Replace Slip Yoke And
1.3 Hrs.
Remove Spillage Seal
From Transfer Case
DEALER CODING
CONDITION
BASIC PART NO.
CODE
4841
41
OASIS CODES: 597997, 702000, 702200, 702300