F 150 4WD Pickup V8-281 4.6L VIN W EFI (1997)
INSTALLATION
1. Install rear oil seal.
-
Use Seal Replacer.
2. Install the rear driveshaft.
(1) Position the rear driveshaft.
(2) Install the four rear driveshaft flange bolts.
NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original positions.
3. Lower the vehicle.
NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
