F 150 4WD Pickup V8-302 5.0L (1986)
4.
Remove snap ring retaining axle shaft in hub body assembly.
5.
Remove lock ring seated in groove of wheel hub.
6.
Remove body assembly from hub. If body is difficult to remove, install two cap screws and pull body assembly out of hub.
7.
Using suitable tool, remove outer locknut from spindle.
8.
Remove lock washer from spindle.
9.
Using suitable tool, remove inner locknut from spindle.
10.
Remove hub and rotor assembly from spindle.
11.
Remove nuts attaching spindle to knuckle, then lightly tap spindle with soft hammer to remove from knuckle.
12.
Remove splash shield and caliper support from knuckle.
13.
Pull axle shaft assembly out of steering knuckle.
14.
Reverse procedure to install, then adjust wheel bearings.
