F 150 4WD Pickup V8-4.6L SOHC VIN W (1998)
Selector Shaft: Service and Repair
MANUAL CONTROL LEVER SHAFT SEAL
REMOVAL
1. Disconnect battery ground cable.
2. Raise and support the vehicle.
3. On 4x4 vehicles, remove the front driveshaft.
1
Remove the eight front driveshaft bolts (four each end).
2
Remove the front driveshaft.
NOTE: Mark the driveshaft flange and rear axle companion flange for correct alignment during installation.
4. Drain the transmission fluid and remove the fluid pan and filter.
5. Disconnect digital Transmission Range (TR) sensor electrical connector.
6. Disconnect the transmission shift linkage.
