F 150 4WD Pickup V8-4.6L SOHC VIN W (1998)
7. Connect the molded lead frame to the sensors.
^
Connect the bulkhead inter connector.
^
Connect the Electronic Pressure Control (EPC) solenoid.
^
Connect the TCC.
^
Connect the shift solenoid SSA/SS1 and SSB/SS2.
8. Replace fluid filter and seal as required.
CAUTION: If installing a new filter, and the grommet remains in the main control bore, carefully use a small screwdriver to remove the
grommet. Use care not to damage the main control bore.
NOTE: If transmission is being serviced for a contamination-related failure, use a new filter and seal. The filter may be reused if no excessive
contamination is present.
9. Position the (B) pan magnet into the (A) transmission fluid pan.
