F 150 4WD Pickup V8-4.6L SOHC VIN W (1998)
3. Make sure the cups are properly seated in their bores.
^
If a feeler gauge of the specification shown in the illustration can be inserted between a cup and the bottom of its bore at any point around the
cup, the cup is not properly seated.
CAUTION: Whenever the cups are replaced, the differential pinion bearings must also be replaced.
4. Assemble and position the Pinion Depth Gauge.
1
Position the Screw.
2
Position the Aligning Adapter.
3
Position the Gauge Disc.
4
Position the Gauge Block.
5
Position the inner pinion bearing.
6
Position the outer pinion bearing.
7
Thread on the Driver Handle.
NOTE: Apply only a light oil film on the pinion bearings before assembling the tool.
5. Tighten the Driver Handle.
