F 150 4WD Pickup V8-4.6L SOHC VIN W (1998)
6. Install a new bearing cup into the driveshaft yoke.
1
Start a new bearing cup into the driveshaft yoke.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft in the U-Joint Tool.
4
Press the bearing cup below the yoke surface.
7. Install new snap rings.
8. Check the U-joints for freedom of movement.
^
If bearings are binding, strike the yoke with a plastic hammer.
NOTE: Do not strike the bearings.
