F 150 4WD Pickup V8-4.6L VIN W (2006)
Early build Mark LT
5. NOTE: Anytime the rear bumper arm-to-rear bumper bolts are removed, discard and install new rear bumper arm-to-rear bumper bolts.
If equipped, remove the rear bumper arm-to-rear bumper bolts.
-
To install, tighten to 175 Nm (129 lb-ft).
Late build Mark LT and all F-150
6. NOTE: Anytime the rear bumper nuts are removed, discard and install new rear bumper nuts.
Remove the rear bumper nuts.
-
To install, tighten to 175 Nm (129 lb-ft).
All vehicles
7. Remove the rear bumper.
8. To install, reverse the removal procedure.
-
Transfer components as necessary. If equipped with a rear parking aid sensor, refer to Collision Avoidance and Parking Assist Systems for
additional information.
