F 150 4WD Pickup V8-4.6L VIN W (2006)
Front Door Window Motor: Service and Repair
Front Door Window Regulator and Motor
FRONT DOOR WINDOW REGULATOR AND MOTOR
Removal and Installation
1. Remove the front door trim panel.
2. Remove the front door watershield.
3. Secure the front door window glass in the full UPWARD position with tape.
4. Remove the front door window glass-to-regulator assembly bolts.
-
Loosen the glass clamp fasteners through the 2 vertical slots in the inner door panel.
-
To install, tighten to 9 Nm (80 lb-in).
5. Disconnect the front door window electrical connector.
6. Remove the front door window regulator bolts.
-
To install, tighten to 11 Nm (8 lb-ft).
7. Remove the front door window regulator and motor.
8. To install, reverse the removal procedure.
