F 150 4WD Pickup V8-4.6L VIN W (2006)
17. Remove the hog rings and the seat cushion trim cover.
18. To install, reverse the removal procedure.
19. Install the seat and repower the SRS. Do not prove out the system at this time.
Passenger seat
20. CAUTION:
-
Make sure the seat is completely assembled before rezeroing.
-
The following precautions must be taken before rezeroing the OCS system:
-
Make sure the OCS system components are connected and no faults are present.
-
Make sure the OCS system is not at a temperature below 0°C (32°F) or above 45°C (113°F) when initiating the rezeroing process.
If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature within
the limits, 0°C to 45°C (32°F to 113°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before rezeroing and nothing is placed on the seat during the rezeroing
process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the rezeroing process.
NOTE:
-
For best results in rezeroing, the OCS system should be at or near room temperature, 10°C to 29°C (50°F to 85°F).
-
If the first attempt to rezero the OCS system is unsuccessful, a second attempt must be made.
-
The ignition switch must be cycled after rezeroing the OCS system.
Rezero the occupant classification sensor.
-
With the front passenger seat empty, use a diagnostic tool to trigger the active command and rezero the occupant classification sensor.
21. NOTE: The ignition switch must be cycled after rezeroing the OCS system.
Cycle the ignition switch from ON to OFF.
All seats
22. Prove out the supplemental restraint system (SRS) as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately 6 seconds and then turn OFF. If an air bag supplemental
restraint system (SRS) fault is present, the air bag indicator will:
-
fail to light.
-
remain lit continuously.
-
flash.
The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag indicator and any SRS fault discovered must be diagnosed and
repaired.
Clear all continuous DTCs from the restraints control module using a diagnostic tool.
Front Seat Cushion Cover - 20 Percent
FRONT SEAT CUSHION COVER - 20 PERCENT
Removal and Installation
1. Remove the 20 percent seat cushion.
