F 150 4WD Pickup V8-4.6L VIN W (2006)
Body Control Module: Service and Repair
Vehicle Security Module
Regular Cab
VEHICLE SECURITY MODULE - REGULAR CAB
Removal and Installation
CAUTION: Prior to the removal of the vehicle security module, it is necessary to upload the module configuration information to the diagnostic tool.
This information needs to be downloaded into the new module once installed.
1. Remove the LH B-pillar trim panel.
2. Disconnect the 2 vehicle security module electrical connectors.
3. Remove the 2 screws and the vehicle security module.
-
To install, tighten to 7 Nm (62 lb-in).
4. To install, reverse the removal procedure.
-
Download the module configuration information from the diagnostic tool into the new module.
SuperCab and SuperCrew
VEHICLE SECURITY MODULE - SUPERCAB AND SUPERCREW