F 150 4WD Pickup V8-4.6L VIN W (2006)
Child Seat Tether Attachment: Service and Repair
Child Safety Seat Tether Anchor
CHILD SAFETY SEAT TETHER ANCHOR
Child Safety Seat Tether Anchor
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS] if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
1. To access the tether anchors, remove the rear seat backrest.
2. Remove the back of cab panel insulator.
-
Remove the pushpins and release the retaining clips.
-
Remove the back of cab panel insulator.
3. Remove the tether anchor bolt(s) and tether anchor(s).
-
To install, tighten to 30 Nm (22 lb-ft).
4. To install, reverse the removal procedure.
