F 150 4WD Pickup V8-4.6L VIN W (2006)
Installation
1. Using the special tool, install a new Teflon seal on the high pressure line fitting.
2. Position the high pressure line and connect the high pressure line fitting-to-pump.
^
If equipped with 4.6L or 5.4L engine, tighten to 65 Nm (48 ft. lbs.).
^
If equipped with 4.2L engine, tighten to 20 Nm (15 ft. lbs.).
3. Install the high pressure line bracket-to-engine bolt on the 5.4L or the nut on the 4.2L and 4.6L.
^
If equipped with a 4.2L or 4.6L engine, tighten to 11 Nm (8 ft. lbs.).
^
If equipped with a 5.4L engine, tighten to 40 Nm (30 ft. lbs.).
4. Remove the high pressure line bracket-to-crossmember bolt.
^
Tighten to 11 Nm (8 ft. lbs.).
5. Install a new O-ring seal and position the high pressure line on the steering gear.
6. Rotate the power steering line clamp plate install the bolt.
^
Tighten to 23 Nm (17 ft. lbs.).
7. Fill the power steering system.
