F 150 4WD Pickup V8-4.6L VIN W (2006)
NOTE: 4.6L and 5.4L engine shown, 4.2L engine similar.
Removal
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Release the clamp and disconnect the suction line from the power steering pump.
^
Allow the fluid to drain into a suitable container.
3. Remove the power steering pump pulley.
4. Disconnect the pressure line fitting-to-pump and position the high pressure line aside.
^
Discard the Teflon seal.
5. Remove the power steering pump.
4.6L, 5.4L engines
6. Remove the 3 power steering pump bolts.
4.2L engine
7. Remove the 4 power steering pump bolts.
Installation
All vehicles
1. Using the special tool, install a new Teflon seal on the pressure line fitting.
4.6L, 5.4L engines
2. Position the power steering pump and install the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
4.2L engine
3. Position the power steering pump and install the 4 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
All vehicles
4. Position the high pressure line and connect the fitting to the power steering pump.
^
If equipped with a 4.6L or 5.4L engine, tighten to 65 Nm (48 ft. lbs.).
