F 150 4WD Pickup V8-4.6L VIN W (2006)
3. Install the manual control lever shaft.
1. Install the manual control lever shaft.
2. Install the inner manual control lever shaft nut.
^
Tighten to 31 Nm (23 ft. lbs.).
3. Install the manual valve control lever shaft retaining pin.
4. Install the manual valve detent lever spring and bolt.
^
Tighten to 10 Nm (89 inch lbs.).
5. Install the digital TR sensor and loosely install the bolts.
6. NOTE: The manual lever must be in the NEUTRAL position.
Using the special tool, align the digital TR sensor slots. The tool is designed to fit snug.
