F 150 4WD Pickup V8-4.6L VIN W (2006)
2. Remove the front driveshaft shield nuts and the front driveshaft shield.
^
To install, tighten to 25 Nm (18 ft. lbs.).
3. Index-mark the front driveshaft flange to the pinion flange to maintain alignment during installation.
4. Index-mark the rear driveshaft flange to the transfer case flange to maintain alignment during installation.
5. Remove the 4 driveshaft flange bolts from the transfer case
^
To install, tighten to 103 Nm (76 ft. lbs.).
6. Remove the 4 driveshaft flange bolts from the pinion flange.
^
To install, tighten to 103 Nm (76 ft. lbs.).
