F 150 4WD Pickup V8-4.6L VIN W (2006)
vehicle.
5.
Note the manufacture code on the wiper motor. If the code cannot be seen AND there is a small label affixed to the wiper motor cylindrical
housing, remove and discard the label. The code may be under the label.
6.
Proceed to Inspection Results in this Attachment III.
EXPLORER, MOUNTAINEER
1.
Remove both wiper arms by lifting the arms slightly and releasing the lock tabs, then remove the arms off of the shafts.
2.
Remove the passenger side, then the driver side cowl grille panels.
3.
Note the manufacture code on the wiper motor. If the code cannot be seen AND there is a small label affixed to the wiper motor cylindrical
housing, remove and discard the label. The code may be under the label.
4.
Proceed to Inspection Results in this Attachment III.
F-150, MARK LT
1.
Remove the wiper arms by releasing the lock tabs and lifting the arms off of the shafts.
2.
Remove the cowl grille panel plastic pin-type retainers (one per panel located near the fenders).
3.
CAUTION: To avoid breaking the retainer hooks on the cowl grille panel, do not pull on the rear of the panel.
A)
Remove the left (driver side) cowl grille panel, then the right (passenger side) panel.
B)
Release the FRONT EDGE of the panel as follows:
^
Starting at the center of the vehicle, depress the forward tab and press upward on the forward edge of the panel to release it from the
cowl.
^
Continuing outward from the center of the vehicle, depress the remaining forward tabs and release the rest of the panel from the cowl.
C)
Release the REAR EDGE of the panel as follows:
^
Starting at the left fender, press down on the rear edge of the panel to release the retaining hook, then lightly pull the front edge of the
panel forward.
^
Continuing toward the center of the vehicle, release the remaining hooks by pressing the panel down while gently pulling the panel
forward.
D)
Disconnect the windshield washer hose and remove the cowl grille panel from the vehicle.
4.
Note the manufacture code on the wiper motor. If the code cannot be seen AND there is a small label affixed to the wiper motor cylindrical
housing, remove and discard the label. The code may be under the label.
5.
Proceed to Inspection Results in this Attachment III.
RANGER
1.
Open the hood and locate the wiper motor.
2.
Note the manufacture code on the wiper motor. If the code cannot be seen AND there is a small label affixed to the wiper motor cylindrical
housing, remove and discard the label. The code may be under the label.
3.
Proceed to Inspection Results in this Attachment III.
TAURUS
1.
Park the wipers in the highest position on the glass.
2.
Remove the wiper arm nut covers.
3.
Remove the nuts then pull the wiper arms up off of the shafts.
