F 150 4WD Pickup V8-5.4L CNG VIN M (2001)
Seat Belt Buckle: Service and Repair
Rear
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
NOTE:
^
New safety belt buckles, height adjusters, center adjust tongues, and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue, and belt and buckle assembly
or the center adjust tongue, and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and
buckles, center adjust tongues, and belts and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of
the vehicle being repaired. Safety belt assemblies must not be interchanged between vehicle models.
^
The driver and middle rear passenger safety belt buckles are shown, the middle rear safety belt and passenger side rear safety belt buckle are
similar.
1. Flip the 60% or 40% rear seat cushion forward.
2. Remove the safety belt buckle assembly.
1
Using the special tool 501-010 (T77L-2100-A) remove the bolt.
2
Remove the safety belt buckle assembly.
3. Remove the safety belt and buckle assembly.
1
Using the special tool 501-010 (T77L-2100-A), remove the bolt.
2
Remove the safety belt and buckle assembly.
INSTALLATION
1. To install, reverse the removal procedure.
