F 150 4WD Pickup V8-5.4L SOHC VIN 3 (1999)
1. Lubricate the brake backing plate friction points. Use Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A (Motorcraft
WA-10) or an equivalent silicone compound meeting Ford specification ESE-M1C171-A.
2. Install the rear brake shoes and linings.
1
Position the rear brake shoes and linings.
2
Install the brake shoe hold-down spring pins and the brake shoe hold-down springs.
3
Install the brake shoe anchor pin guide plate.
3. NOTE: To prevent incorrect installation, the socket end of each brake adjuster screw is stamped R or L.
Assemble the brake adjuster screw assembly.
1
Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or an equivalent silicone compound
meeting Ford specification ESE-M1C171-A.
2
Install the brake adjuster screw into the brake shoe adjusting screw nut to the end of the threads, and then loosen one-half turn.
3
Install the brake shoe adjusting screw socket on the brake shoe adjusting screw nut.
4. Install the brake adjuster screw assembly.
