F 150 4WD Pickup V8-5.4L SOHC VIN 3 (1999)
LABOR ALLOWANCES
PARTS REQUIREMENTS
Safety Certification Partial Overlay Labels and installation instructions will be mailed to the vehicle owners. In addition, the owners will be notified that
if they prefer, they may have the dealership personnel install the label at no charge. Labels and instructions for vehicles not reported as sold will be
included in the Ford Dealership Consolidated Communicator (FDCC). If the customer no longer has the label, call the Recall Hotline (1-800-325-5621).
When calling this number to order labels and instructions, be prepared to give the recall number 99S03.
Attachment III - Technical Information
IMPORTANT NOTICE TO OWNERS OF TWO (2) OR MORE F-150 TRUCKS
The Safety Certification Label is matched to the Vehicle Identification Number (VIN) for each letter.
To make sure that the correct label is attached to the correct vehicle, do not separate the Safety Certification Labels from the letters until you are ready to
attach the label to the truck.
INSTRUCTIONS FOR ATTACHING THE LABEL
1.
Open the driver's door and locate the "Safety Certification Label", on the "B" pillar at the door opening. See Figure 1.
2.
Verify that the VIN on the letter is the same as the VIN on the vehicle.
NOTE:
The vehicle VIN is located in two places: a) behind the left lower corner of the windshield and b) on the driver's door "B" pillar Safety Certification
Label.
3.
Clean the label and surrounding area with the supplied Label Adhesive Cleaning Pad.
4.
Remove the partial label from the letter and place it over the cleaned area so the partial label is directly over the upper portion of the label as
illustrated by the unshaded area of Figure 1. Use care not to cover the other information on the existing label. Smooth out air bubbles with a clean
cloth.
