F 150 4WD Pickup V8-5.4L SOHC VIN 5 (2004)
6. When fuel system service is complete, connect the electrical connector.
7. Position back the splash shield and install a new push pin.
8. NOTE: It may take more than one key cycle to pressurize the fuel system.
Cycle the ignition key and wait three seconds to pressurize the fuel system. Check for leaks before starting the engine.
9. Install the scan tool. Turn the key ON with the engine OFF. Cycle the key OFF, then ON. Select the appropriate vehicle and engine qualifier. Clear
all diagnostic trouble codes (DTCs) and carry out a PCM reset.
10. Start the vehicle and check the fuel system for leaks.