F 150 4WD Pickup V8-5.4L VIN V Flex Fuel (2006)
Remove the seat track control handle retaining clip.
6. NOTE: Driver seat without SIR shown, others similar.
Detach the seat track control handle and remove the outboard seat track.
7. NOTE: Driver seat without SIR shown, others similar.
Rotate the seat track control handle to relieve the spring tension and detach the seat track control handle from the inboard seat track.
8. To install, reverse the removal procedure.
9. Install the seat and repower the SRS. Do not prove out the system at this time.
Passenger seat
10. CAUTION:
-
Make sure the seat is completely assembled before rezeroing.
-
The following precautions must be taken before rezeroing the OCS system:
-
Make sure the OCS system components are connected and no faults are present.
-
Make sure the OCS system is not at a temperature below 0°C (32°F) or above 45°C (113°F) when initiating the rezeroing process.
If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature within
the limits, 0°C to 45°C (32°F to 113°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before rezeroing and nothing is placed on the seat during the rezeroing
process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the rezeroing process.
NOTE:
-
For best results in rezeroing, the OCS system should be at or near room temperature, 10°C to 29°C (50°F to 85°F).
-
If the first attempt to rezero the OCS system is unsuccessful, a second attempt must be made.
-
The ignition switch must be cycled after rezeroing the OCS system.
Rezero the occupant classification sensor.
-
With the front passenger seat empty, use a diagnostic tool to trigger the active command and rezero the occupant classification sensor.
11. NOTE: The ignition switch must be cycled after rezeroing the OCS system.
Cycle the ignition switch from ON to OFF.
All seats
