F 150 4WD Pickup V8-5.4L VIN V Flex Fuel (2006)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
Oil Level Indicator and Tube
Material
Removal and Installation
1. Remove the front oil level indicator and tube bolt.
^
To install, tighten to 25 Nm (18 ft. lbs.).
2. Remove the rear oil level indicator and tube bolt.
^
To install, tighten to 10 Nm (89 inch lbs.).
3. Remove the oil level indicator and tube from the cylinder block.
^
Discard the O-ring seal.
4. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.