F 150 4WD Pickup V8-5.4L VIN V Flex Fuel (2006)
-
Discard the O-ring seal.
-
To install, tighten to 25 Nm (18 lb-ft).
6. Remove the suction accumulator outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
7. Remove the compressor manifold and tube assembly.
8. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
9. Evacuate, leak test and charge the refrigerant system.