F 150 4WD Pickup V8-5.4L VIN V Flex Fuel (2006)
4. Remove the slip-yoke boot from the driveshaft.
^
Inspect the boot for damage. Discard the boot as necessary.
5. Inspect the lubricant on the driveshaft splines and in the driveshaft slip yoke for contamination. If contaminated, inspect the driveshaft splines and
the driveshaft slip yoke for wear. Install new components as necessary.
Installation
1. Position the new small driveshaft slip-yoke boot clamp on the driveshaft stub shaft.
2. Slide the small opening end of the slip-yoke boot on the driveshaft stub shaft, as far as it will travel.
3. Using the special tool, crimp the driveshaft slip-yoke boot clamp.
