F 150 4WD Pickup V8-5.4L VIN V Flex Fuel (2006)
8. NOTE: LH side shown, RH side similar.
Slowly release the clamp on the cable to gradually unload the tensioning spring on the motor housing.
9. NOTE: LH side shown, RH side similar.
Remove the cable swag from the guide bracket on the sliding rear window.
All vehicles
10. If equipped, disconnect the heated rear backlight connectors.
11. Remove the rear window glass nuts.
12. Remove the rear window glass from the vehicle.
13. Remove any remaining foam butyl from the rear window glass frame.
Installation
All vehicles
1. Clean the rear window glass with an alcohol-free cleaner.
2. Apply an 8 mm (0.31 in) bead of foam butyl to the rear window glass, starting at the bottom middle of the rear window glass, working around.
3. Install the rear window glass.
4. Install the rear window glass nuts.
-
Tighten to 4 Nm (35 lb-in).
5. If equipped, connect the heated rear backlight connectors.
Power sliding rear window
6. CAUTION: The following substeps are to prevent the cables from popping out of the motor housing. If an existing regulator and motor
assembly is to be reused, do not allow the cables to pop out of the motor housing, as they can unwind from the drum. If the cables unwind
from the drum, a new regulator and motor assembly will have to be installed.
NOTE: LH side shown, RH side similar.
Install the LH cable first, then the RH side cable. Install the cable swag into the guide bracket on the sliding rear window.
