F 150 Heritage 2WD Pickup V8-4.6L SOHC VIN W (2004)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
Reservoir
Removal
WARNING: Use of any other than approved DOT 3 brake fluid will cause permanent damage to brake components and will render the
brakes inoperative.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake
fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water
and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. Disconnect the brake master cylinder fluid level warning switch.
2. Use a suitable suction device to drain the brake master cylinder reservoir.
3. Carefully pry up on the brake master cylinder reservoir to remove.
Installation
1. NOTE: Whenever installing a new brake master cylinder reservoir, install new grommets.
Install the brake master cylinder reservoir.
1
Lubricate the two grommets with High Performance DOT 3 Brake Fluid C6AZ-19542-AB or equivalent DOT 3 fluid meeting Ford
