F 150 Heritage 2WD Pickup V8-4.6L SOHC VIN W (2004)
12. Lower and remove the valve body separator plate and gaskets.
^
The rubber check balls and the steel EPC check ball and spring assembly will fall out and may become lost or stick to the worm trail of the
case.
^
Remove and discard separator plate gaskets.
Installation
CAUTION: Using the incorrect gaskets can cause damage to the transmission.
NOTE: If the valve body separator plate was not removed, proceed to Step 6.
NOTE: Apply a light film of petroleum jelly to the valve body separator plate prior to assembling the new gaskets.
Assemble the new gaskets to the valve body separator plate.
1
Main control-to-case gasket
2
Valve body separator plate
3
Main control-to-separator plate gasket
