F 150 Heritage 4WD Pickup V6-4.2L VIN 2 (2004)
3. Remove the safety belt and buckle assembly.
1
Using the special tool 501-010 (T77L-2100-A), remove the bolt.
2
Remove the safety belt and buckle assembly.
INSTALLATION
1. NOTE:
-
The double safety belt buckle assembly or safety belt and buckle assembly must be installed on top of the rear seat riser.
-
Make sure that the belt webbing is not twisted prior to installation.
-
Apply Ford Threadlock 262 (E2FZ-19554-B) or equivalent to fasteners when installing safety belt buckle or retractor assemblies.
-
Make sure to tighten bolts to specification.
To install, reverse the removal procedure.
-
Route the rear center safety belt and tongue through the safety belt retaining strap on the rear seat back.
-
See the removal procedure or Specifications for torque specifications.
2. Check the restraints system for correct operation.