F 150 Heritage 4WD Pickup V8-5.4L CNG VIN M (2004)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
1. CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
Disconnect the battery ground cable.
2. Disconnect the anti-lock brake control module electrical connector.
3. Disconnect the pump motor electrical connector from the anti-lock brake control module.
4. Remove the screws and the anti-lock brake control module.
5. NOTE: At the first key-on after a new ABS module is installed, use the NGS with the service card to configure the module. For additional
information, Information Bus.
To install, reverse the removal procedure.
