F 150 Heritage 4WD Pickup V8-5.4L CNG VIN M (2004)
5.
Remove the plastic rear stud retainer from the bottom of the wiring harness. Relocate this retainer approximately 3/4" (20 mm) rearward and fasten
it to the TOP of the harness (Figure 2).
6.
Remove the front stud retainer from the harness and reposition the harness as needed to remove any slack that may be present.
7.
Reinstall the retainers on the cam cover studs.
8.
Tape down coil number 4 take out.
9.
Verify there is no contact between the A/C line and the wiring harness (Figure 3).
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
OPERATION
DESCRIPTION
TIME
042110A
Check For Diagnostic
0.7 Hr.
Trouble Codes, Inspect,
And Relocate Wire
Harness (For Any Wire
Repairs Refer To TSB
03-11-06 Use Actual Time
In Accordance With The
Warranty And Policy
Manual Guidelines)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
12B637
30
