F 150 Heritage 4WD Pickup V8-5.4L CNG VIN M (2004)
2. Install the front suspension arm lower ball joint castellated nut.
1
Position the front wheel knuckle.
2
Install the front suspension arm lower ball joint castellated nut.
3
Install a new cotter pin.
3. Install the tie rod end castellated nut.
1
Position the tie rod end.
2
Install the tie rod end castellated nut.
3
Install a new cotter pin.
4. CAUTION: The torsion bar adjustment bolt is coated with dry Loctite and must be replaced if it is backed off or removed. Failure to do so can
cause the adjustment bolt to loosen up during operation and a loss of vehicle alignment.
Preload the torsion bar.
1
Tighten the torsion bar tool until the new adjustment bolt and nut can be installed.
2
Turn the adjustment bolt until preliminary adjustment marks are aligned.