F 150 Heritage 4WD Pickup V8-5.4L CNG VIN M (2004)
13. Install the rear driveshaft.
1
Position the driveshaft.
2
Install the four bolts.
All vehicles
14. Lower the vehicle.
15. Fill the transmission with clean automatic transmission fluid.
^
Verify for correct operation.
^
Check for leaks.
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal
Special Tools And Equipment
Special Tool(s)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: Mark the driveshaft flange and rear axle pinion flange for correct alignment during installation.
On 4x4 vehicles, remove the front driveshaft.
1
Remove the eight front driveshaft bolts (four each end).
2
Remove the front driveshaft.
3. Drain the transmission fluid and remove the fluid pan and filter.
4. Disconnect digital TR sensor electrical connector.
