F 150 Heritage 4WD Pickup V8-5.4L CNG VIN M (2004)
5. Remove the pinion nut.
^
Use a suitable companion flange holding tool.
6. Remove the rear axle pinion flange, using the special tool.
^
Remove the rear axle drive pinion seal.
^
Remove the rear axle drive pinion shaft oil slinger.
7. Install the special tool and, with a soft-faced hammer, drive the pinion out of the front bearing cone and remove it through the rear of the housing.
8. NOTE: Remove the collapsible spacer and discard it.
Using the special tool, remove the pinion bearing.
