F 150 Heritage 4WD Pickup V8-5.4L CNG VIN M (2004)
9. Remove the bearing cups and the driveshaft center yoke.
1
Position the driveshaft center yoke in the special tool.
2
Press out a bearing cup.
3
Rotate the driveshaft center yoke 180 degrees.
4
Press on the spider to remove the opposite bearing cup.
5
Remove the driveshaft center yoke.
10. Remove the bearing cups and the spider.
1
Position the driveshaft yoke in the special tool.
2
Press out a bearing cup.
3
Rotate the driveshaft yoke 180 degrees.
4
Press on the spider to remove the opposite bearing cup.
5
Remove the spider.
Assembly
1. Install the new spider and bearing cups.
1
Start a new bearing cup in the driveshaft yoke.
^
Check the needle bearings for correct positioning.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft yoke in the special tool.
4
Press the bearing cup to just below the snap ring groove.
^
Repeat to install the new bearing cup on the opposite side of the driveshaft yoke.