ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Air Bag Control Module|Removal and Installation|Page 8426 > < Technician Safety Information|Page 8423
Page 1
background image

Air Bag Control Module: Service and Repair
Removal and Installation

RESTRAINTS CONTROL MODULE

Special Tool(s)

SPECIAL TOOL(S)

REMOVAL

WARNING:

-

The restraints control module (RCM) orientation is critical for proper system operation. If a vehicle equipped with an air bag
supplemental restraint system (SRS) has been involved in a collision in which the center tunnel area has been damaged, inspect the
mounting and bracket for deformation. If damaged, the RCM must be replaced whether or not the air bags have deployed. In addition,
make sure the area of the RCM mounting is restored to its original condition.

-

Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the
sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.

CAUTION:  Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.

NOTE:  Repair is made by installing a new part only. If a new part does not correct the condition, install the original part and perform the diagnostic
procedure again.

1. Prepare the vehicle for restraints control module (RCM) removal.

1

WARNING:  To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before
repairing or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing,
adjusting or striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches,
strikers, seats and hood latches.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).

Disconnect the battery ground cable and wait at least one minute.

2

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.

Deactivate the supplemental restraint system (SRS).

Air Bag Control Module|Removal and Installation|Page 8426 > < Technician Safety Information|Page 8423