F 150 Super Crew 2WD V8-4.6L SOHC VIN 6 (2003)
Keyless Entry Transmitter: Service and Repair
REMOTE TRANSMITTER PROGRAMMING
NOTE:
-
All keyless entry remote transmitters must be programmed at the same time.
-
Programming (or reprogramming) the keyless entry remote transmitters into the central security module can be accomplished using a diagnostic
tool or by carrying out the following steps.
1. Turn the ignition switch from OFF to RUN eight times within 10 seconds, ending in RUN. If the module has successfully entered program mode,
it will lock and then unlock all doors.
2. Within 20 seconds, press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless
entry remote transmitter has been programmed. Repeat this step for each transmitter.
3. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again. If the door locks still fail
to respond, refer to Inspection and Verification.
4. Turn the ignition switch to the OFF position, or wait up to 20 seconds after Step 2, to exit program mode. If a keyless entry remote transmitter has
been programmed (or reprogrammed), the doors will lock and unlock one last time to confirm.
