ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Technician Safety Information|Page 8473 > < Seat Regulator Control Switch|Page 8468
Page 1
background image

Seat Cushion: Technician Safety Information

WARNING:

-

Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.

-

After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generated combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.

-

The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in personal injury.

-

To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or striking
components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).

-

To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the supplemental restraint
system (SRS) deactivation/reactivation procedure.

-

To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat removal and
installation procedure.

-

The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use. Failure to remove
could result in injury and possible violation of vehicle safety standards.

-

To reduce the risk of serious personal injury, read and follow all warnings, cautions, and notes at the beginning of the disassembly
procedure.

-

The metal edges of seat cushion pan can be sharp.

Technician Safety Information|Page 8473 > < Seat Regulator Control Switch|Page 8468