F 150 Super Crew 2WD V8-4.6L SOHC VIN 6 (2003)
Brake Caliper: Service and Repair
Front
Caliper Removal and Installation
Removal
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. WARNING: Asbestos fiber dust maybe be present on brake and clutch assemblies and is hazardous to health if inhaled.
Brake and clutch assemblies should be cleaned using a vacuum cleaner recommended for use with asbestos fibers such as a brake/clutch/service
Acura. The bag must be labeled per OSHA instructions, sealed, and the trash hauler notified as to the bag's contents.
If a vacuum suitable for asbestos is not available, cleaning should be done wet. If dust generation is still possible, technicians should wear
government-approved toxic dust purifying respirators.
Occupational health and safety act (OSHA) requires areas where asbestos dust generation is possible to be isolated and posted with warning signs.
Only technicians performing brake or clutch repair should be` present in the area.
WARNING: Use of any brake fluid other than approved DOT 3 will cause permanent damage to brake components anti will render the brakes
inoperative.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes' flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally,
drink water and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
with water.
NOTE: Use clean fresh Ford High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification
ESA-M6C25A
^
Do not reuse brake tepid drained or bled from the system
^
Do not use brake fluid that has been stored in an open container
^
Do not use contaminated brake fluid
Disconnect the fixing brake. hose
1. Remove the front brake hose bolt
2. Disconnect the front brake hose.
3. Remove and discard the copper washers
Plug the front brake hose.
