F 150 Super Crew 2WD V8-4.6L SOHC VIN 6 (2003)
9. Install the two driver air bag module bolts (one shown).
10. Install the two steering wheel back cover plugs.
11. Turn the ignition switch from OFF to ON.
12. Install the restraints control module fuse F2.22 (10A) to the CJB and install the cover.
Warning: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the battery
ground cable is connected.
13. Connect the battery ground cable.
14. Prove out the supplemental restraint system (SRS) as follows: Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to
ON and visually monitor the air bag indicator with the air bag modules installed. The air bag indicator will light continuously for approximately
six seconds and then turn off. If an air bag supplemental restraint system (SRS) fault is present, the air bag indicator will either:
-
fail to light.
-
remain lit continuously.
-
flash.
The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of five sets of five beeps. If this occurs, the air bag indicator and any SRS fault discovered must be
diagnosed and repaired. Clear all continuous DTCs from the restraints control module using a scan tool.
