F 150 Super Crew 2WD V8-4.6L SOHC VIN 6 (2003)
1. Position the RCM. Install the bolts.
WARNING: THE TIGHTENING TORQUE OF THE RESTRAINTS CONTROL MODULE (RCM) RETAINING BOLTS IS
CRITICAL FOR CORRECT SYSTEM OPERATION.
2. Connect the RCM electrical connector.
3. Position the lower center instrument panel finish panel. Install the two pin-type retainers.
4. Connect the battery ground cable.
5. With the restraint system diagnostic tools installed at all deployable devices, prove out the supplemental restraint system (SRS). See: Air Bag
Systems/Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure
6. Disconnect the battery ground cable and wait at least one minute.
7. Restore the vehicle to operating condition.
1
Reactivate the supplemental restraint system (SRS).
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS,
CAUTIONS, NOTES, AND INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
DEACTIVATION/REACTIVATION PROCEDURE.
2
With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). See: Air Bag Systems/Air Bag(s)
Arming and Disarming/Service and Repair/Prove Out Procedure
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE
FROM THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE
VIOLATION OF VEHICLE SAFETY STANDARDS.
