F 150 Super Crew 2WD V8-4.6L SOHC VIN 6 (2003)
11. Install the head restraint.
1
Insert the head restraint rods into the rod guides.
2
Press release button and push the head restraint rod past its stop position.
3
Using a flat-blade screwdriver, press the release tab on the second head restraint rod guide and push the head restraint rod into the rod guide.
12. Install the front seat backrest.
13. Install the front seat.
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS,
NOTES AND INSTRUCTIONS IN THE FRONT SEAT REMOVAL AND INSTALLATION PROCEDURE.
14. Reactivate the supplemental restraint system (SRS) deactivation/reactivation procedure.
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS,
NOTES AND INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION/REACTIVATION
PROCEDURE. Refer to: Air Bag(s) Arming and Disarming.
15. With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
16. Check the active restraints for correct operation.
SuperCab
SPECIAL TOOL(S)
REMOVAL
1. Remove the upper rear corner trim panel.
2. Remove the lower corner trim panel.
3. Remove the rear safety belt retractor.
1
Use the special tool to remove the bolt.
2
Remove the rear safety belt retractor.