F 150 Super Crew 2WD V8-4.6L SOHC VIN 6 (2003)
REMOVAL
NOTE: New safety belt buckles, height adjusters, center adjust tongues, and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue, and belt and buckle assembly or the
center adjust tongue, and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and buckles, center
adjust tongues, and belts and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle being
repaired. Safety belt assemblies must not be interchanged between vehicle models.
NOTE: The passenger side is shown. The driver side is similar.
1. Remove the C-pillar trim panel.
2. Using special tool 501-D012 (D83L-2100-A) or equivalent, remove the safety belt anchor.
3. Remove the safety belt retractor.
1
Using the special tool, remove the bolt.
2
Remove the safety belt retractor.
INSTALLATION
1. To install, reverse the removal procedure.
^
Check the active restraints system for correct operation.
NOTE:
^
Make sure the safety belt webbing is not twisted prior to installation.
^
Make sure to tighten nuts and bolts to specification.
Safety Belt Retractor and Pretensioner - Without SIR
