F 150 Super Crew 2WD V8-4.6L SOHC VIN 6 (2003)
9. Install the rear driveshaft.
1
Position the driveshaft.
2
Install the four bolt.
10. Lower the vehicle.
11. Connect the battery ground cable.
12. Fill the transmission with clean automatic transmission fluid and inspect for correct operation.
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal
Special Tool(s)
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. NOTE: Mark the driveshaft flange and rear axle pinion flange for correct alignment during installation.
On 4x4 vehicles, remove the front driveshaft.
1
Remove the eight front driveshaft bolts (four each end).
2
Remove the front driveshaft.
4. Drain the transmission fluid and remove the fluid pan and filter.
5. Disconnect digital TR sensor electrical connector.
