F 150 Super Crew 2WD V8-4.6L SOHC VIN 6 (2003)
Hydraulic Hose: Service and Repair
Hydraulic Tubes
Removal
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking, or towing an air suspension
vehicle. This can be accomplished by turning off the Rh kick panel area. Failure to inflation of deflation of the air springs which may
result in shifting of the vehicle during these operations.
Raise and support the vehicle.
2. Disconnect the line from the plastic clip at the floor flange.
3. Uncouple the lower end of the line from the clutch slave cylinder.
4. Lower the vehicle.
5. Remove the clutch master cylinder and line assembly.
6. Remove and discard the roll pin holding the line to the clutch master cylinder.
7. NOTE: Check that the O-ring is still in the outlet port of the clutch master cylinder. If not, replace it.
Disconnect the line from the clutch master cylinder by applying a slight tug on the line.
Installation
1. Insert the new line into the clutch master cylinder outlet port.
2. Install the clutch master cylinder tube.
1
Position the line and install the roll pin.
2
Tug on the clutch master cylinder tube.
3. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking, or towing an air suspension
vehicle. This can be accomplished by turning off the Rh kick panel area. Failure to inflation of deflation of the air springs which may
result in shifting of the vehicle during these operations.
Raise and support the vehicle.
4. Bleed the system.
5. NOTE: Check that the O-ring is in place on the line. Check the clutch slave cylinder port to be sure there is no O-ring.
Insert the male coupling end into the female coupling of the clutch slave cylinder.
^
Check that the connection is secure by applying a slight tug to the line.
6. Connect the line to the plastic clip on the floor flange.
7. Lower the vehicle.
8. Turn on the air suspension switch, if equipped.
