F 150 Super Crew 2WD V8-4.6L SOHC VIN 6 (2003)
5. Set the driveshaft assembled length to specification.
1
Remove any excess grease from the slip-yoke boot and driveshaft slip-yoke surfaces.
2
Position the slip-yoke boot in the slip-yoke boot groove.
3
Set the driveshaft assembled length to specification.
^
Measure from the stub shaft weld to the U-joint centerline.
4
Bleed the air from the slip-yoke boot.
6. Using the special tool, crimp the large driveshaft slip-yoke boot clamp.