F 150 Super Crew 2WD V8-5.4L Prop SOHC VIN Z (2003)
6. Remove the crossmember bolts and the crossmember.
7. Lower the rear of the transmission to gain access to the sensors.
8. Disconnect the electrical connector of the affected sensor.
9. CAUTION: Use care not to induce contamination in the form of dirt or foreign material when removing either of the sensors.
If necessary, remove the Turbine Shaft Speed (TSS) sensor.
1
Remove the bolt.
2
Remove the TSS.
10. Position the Heated Oxygen Sensor (H02S) connector aside.