F 150 Super Crew 2WD V8-5.4L Prop SOHC VIN Z (2003)
4. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its
components to disconnect the yoke from the flange. Pry only in the area shown with a suitable tool to disconnect the yoke from the flange.
Using a suitable tool as shown, disconnect the driveshaft centering socket yoke from the rear axle pinion flange.
5. Install a Nm (inch-pound) torque wrench on the pinion nut and record the torque required to maintain rotation of the pinion through several
revolutions.
6. Remove the pinion flange and piston nut.
7. Install the special tool. Using a soft-faced hammer, drive the pinion assembly out of the front bearing cone and remove it through the rear of the
housing.
^
Remove the rear axle drive pinion scat.
^
Remove the rear axle drive pinion shall tail slinger.
8. Remove the collapsible spacer and discard it.