F 150 Super Crew 2WD V8-5.4L SOHC VIN L (2001)
3. Bleed the disc brake caliper.
4. Install the wheel and tire assembly.
5. Check the brake system operation.
Caliper Disassembly and Assembly
Disassembly
WARNING: Use of any brake fluid other than approved DOT 3 will cause permanent damage to brake components and will render the
brakes inoperative.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 5 minutes. Get medical attention if irritation persists. If taken internally, drink
water to induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
NOTE: Use clean fresh Ford High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification
ESA-M6C25A.
^
Do not reuse brake fluid drained or bled from the system.
^
Do not use brake fluid that has been stored in an open container.
^
Do not use contaminated brake fluid.
1. Remove the disc brake caliper.
2. Drain remaining brake fluid from the disc brake caliper.
3. Secure the disc brake caliper in a vise.
4. Remove the caliper pistons.
1
Place a block of wood between the caliper bridge and the caliper pistons.
2
Apply low air pressure to the fluid port in the disc brake caliper.
3
Force out the caliper piston to the block of wood.
4
Remove the block of wood and the caliper pistons.
5. Remove and discard the piston seals and boots.
6. NOTE: Do not hone the caliper bores. Pistons are not available for honed caliper bores.
If the caliper bores are excessively scored or corroded, install a new disc brake caliper.
