F 150 Super Crew 2WD V8-5.4L SOHC VIN L (2001)
2. NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U-joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
Remove the shaft from the special tool, and install the new snap ring.
Opposite beating cup installation
3. Repeat Bearing cup installation to install the new bearing cup and snap ring on the opposite side of the shaft yoke.
Slip-yoke installation
4. Inspect the driveshaft slip-yoke. Install a new yoke, if necessary.
5. Install the driveshaft slip-yoke and new bearing cup.
1. Start a new bearing cup in the driveshaft slip-yoke.
^
Check the needle bearings for correct positioning.
2. Position the driveshaft slip-yoke on the spider.
3. Position the assembly in the special tool.
4. Press the bearing cup to just below the snap ring groove.
